Chave codificada da Discovery II

Toribio,

Fico à disposição, se puder ajudar...

Citação:

---

Postado originalmente por ToribioMalagodi

É, não da... A chave veio sem code... Como resolver essa situação?

---

Ah, bão.. Daí acho que tem que comprar outra mesmo :( rimmerbros, lrParts, ebay.. Acho que todas vem com um serial, mas e bom confirmar antes da compra.

Citação:

---

Postado originalmente por Wilsonbelem

Ah, bão.. Daí acho que tem que comprar outra mesmo :( rimmerbros, lrParts, ebay.. Acho que todas vem com um serial, mas e bom confirmar antes da compra.

---

É, vou verificar com o antigo dono primeiro.. Se não der, ai terá q ser a minha primeira importação para Disco hehe

Olá pessoal,

Leiam abaixo onde encontrar o código da chave: Yes, most definitely pecker, it can be done, in fact, just about anything can be done by someone on this forum, you just have to ask and someone will pop up and do it, or point you in the direction of someone else who can http://www.thed2boysclub.co.uk/forum...on_thumbup.gif

On my suspension blipper someone coded for me recently, the number was hidden on the back of the circuit board, I just need to pop it out and jot the number down, put it back together and then they programmed it in for me. I suspect the key will be the same thing http://www.thed2boysclub.co.uk/forum...on_thumbup.gif

Just have a look on the map that airhook posted up and then PM your nearest Nanocom owner http://www.thed2boysclub.co.uk/forum...on_thumbup.gif

Abraço,

Ary
Defender 110 2004

Citação:

---

Postado originalmente por ary nunes

Olá pessoal,

Leiam abaixo onde encontrar o código da chave: Yes, most definitely pecker, it can be done, in fact, just about anything can be done by someone on this forum, you just have to ask and someone will pop up and do it, or point you in the direction of someone else who can http://www.thed2boysclub.co.uk/forum...on_thumbup.gif

On my suspension blipper someone coded for me recently, the number was hidden on the back of the circuit board, I just need to pop it out and jot the number down, put it back together and then they programmed it in for me. I suspect the key will be the same thing http://www.thed2boysclub.co.uk/forum...on_thumbup.gif

Just have a look on the map that airhook posted up and then PM your nearest Nanocom owner http://www.thed2boysclub.co.uk/forum...on_thumbup.gif

Abraço,

Ary
Defender 110 2004

---

Boa!!! E ainda o antigo dono me ajudou... Me passou a resposta do cara.
I?ve sold MANY of these remotes and have not needed (or have) any ?code? to program it. I?m not sure what the dealer is asking for. It is likely that they have very old hardware/software for remote programming and need something that other locksmiths do not require in order to code it.

Please let me know what state you are in and I will provide you with a list of automotive locksmith specialists that can assist in programming this for you. Also, they will do so at a cost MUCH less than your dealer would charge (if they were willing to help. In many cases a dealer does not want to help you if you bring them a remote as they would rather sell you one of theirs and make the commission on it). Again, let me know your state and I will respond with a list of locksmiths that can cut and program this to your vehicle without any such ?code?.

I look forward to your reply and to getting this matter resolved fully (and the remote successfully programmed to your vehicle).

Ou seja, não é necessário ter o code? Mandei perguntando que como é o procedimento para a programação...

Abs